Working with the blender, Hints, Caution – Kompernass KH 700 User Manual

Page 9

Advertising
background image

- 7 -

• Place the lid 0 on the bowl

9 and the pusher w in the
filling shaft q.

• Set the speed controller 7 to

the level recommended in the
table.

Hints:

• Put liquid ingredients into the bowl 9 last and

start mixing at low speed to avoid splashing.

• Never fill the mixing bowl 9 above the

MAX.mark (1.5l).

• For mixing “water like” liquids only use the speed

1 with maximum volume of 1 l to avoid liquid
spilling out.

8. Working with the blender

ƽ

Caution:

• Never switch on the blender when empty.
• Never insert the plug in the socket before the

blender jug 4 and the blender lid 2 have been
correctly assembled.

• Always pull the plug from the socket before

removing the blender jug 4.

• Do not fill ingredients hotter than 80°C in the

blender jug 4.

• To avoid splashing, never add more than 1.5l of

liquid in the blender jug 4.

• Never remove the blender lid 2 during opera-

tion.

• First remove the blender lid 2 before removing

the blender jug 4.

• Never run the blender continuously for more than

3 minutes.

You can use the blender to finely puree and mix in-
gredients. You can use the blender for preparing
soups, sauces, milkshakes, baby food or process ve-
getables and fruit into a puree

• First remove the cover 5 for

the motor block 6 by turning
it clockwise.

• Now place the liquidiser 4 in

the opening, so that the arrow
marking on the liquidiser 4 po-
ints towards the open lock on
the motor block 6. Turn the li-
quidiser 4 anti-clockwise until it
is firmly seated. Ensure that the
arrow marking is pointing to-
wards the closed lock.

• Place the cover 0 on the li-

quidiser 4 so that the arrows
on the handle of the liquidiser
4 and on the cover 0 point
towards each other. Turn the
cover 0 anti-clockwise until it
sits firmly.

• Fill the ingredients in the blen-

der jug 4. Cut them into
smaller pieces beforehand if
required.

• If required, insert the splash

protection cap 1 and turn it
anti-clockwise to secure.

• Switch on the blender by setting the speed

controller 7 to the desired level.

IB_KH700_E41968_LB6 17.11.2008 14:33 Uhr Seite 7

Advertising