Kenwood VR-5080 User Manual
Page 47
41
R
e
mote Setup
Chapter Two : Setting Up the Remote Control Unit
Press the Exit button (LCD function button 2) to exit from
the operation.
Press the Clr (clear) button (LCD function button 1) if you
want to clear the previously programmed remote control
signal and reset to the factory shipment condition. (Cleared
is displayed.)
4. To program remote control signal, place the two units
opposite to each as shown below. On the Remote Con-
trol unit of the selected device, press the button trans-
mitting the desired remote control signal. Complete is
displayed when the remote control signal has been pro-
grammed in this Remote Control unit.
2WAY LCD REMOTE CONTROL UNIT
+
-
+
-
12
3
45
6
78
9
10
11
12
+10
0
+
100
/
8
/
7
1
1
• “Error” is displayed when it failed.
5. To program other remote control signals, repeat steps 1
to 4 for each.
REC
Complete
Extend1
4 inches
(10cm)
REC
Error
Extend1
To change the remote control signal from a Remote
Control unit button (When you select “Nothing” in step
8 on page 39):
1. Select the controlled device (CD, DVD, etc.) by pressing
the MUSIC, MOVIE or TV button.
2. Press the LEARN button.
4. On the Remote Control unit of the selected device, press
the button transmitting the desired remote control sig-
nal. Complete is displayed when the remote control sig-
nal has been programmed in this Remote Control unit.
REC
Waiting
ClrFFExit
REC
Video1
DVD
FFFFFFMenu
Press the Exit button (LCD function button 2) to exit from
the operation.
5. To program other remote control signals, repeat steps 1
to 4 for each.
To reset a button to the factory shipment condition by clear-
ing the previously programmed signal:
Press the Clr button in step 3 of the procedure above.
(Cleared is displayed)
The remote control signal activated by holding the F.SHIFT
button cannot be modified.
example:
REPEAT
“REPEAT” function cannot be modified.
In programming a remote control signal, be sure to use the
Remote Control unit originally provided with the AV de-
vice.
REC
Complete
3. On the Remote Control unit, press the button you want
to change the function.
1
2
3
4
5
6
7
8
9
10
11
12
+10
0
+100
/
8
/
7
1
1
1
2
3
4
5
6
7
8
9
10
11
12
+10
0
+100
/
8
/
7
1
1