Chapter five: warnings and specifications, Warnings, Vr-5700 specifications – Kenwood VR-5080 User Manual

Page 56

Advertising
background image

50

Specifications

Chapter Five : Warnings and Specifications

Chapter Five: Warnings and Specifications

Read this page carefully to ensure safe operation.

VR-5700 Specifications

Audio Section

Rated Output Power during stereo operation

120 watts per channel minimum RMS, both channels
driven, at 6

from 20Hz to 20kHz with no more than

0.03% total harmonic distortion (FTC).

Effective Output Power during surround operation

1 kHz, 0.06% T.H.D. at 6

, all channel driven

(Front, Center, Surround) ....................................... 120 W

×

5

Total Harmonic Distortion ............. 0.005 % (1 kHz, 60 W, 6

)

Frequency Response (IHF’66)

Line (CD1, MD/TAPE, CD2/TAPE2 MONITOR, CD-R,
VIDEO 1 - 4, DVD/6CH.) ......... 7 Hz ~ 100 kHz, 0 dB, -3 dB

Signal to Noise Ratio (IHF ‘66)

PHONO (MM) ............................................................... 76 dB
CD1 .................................................................................. 98 dB

Input Sensitivity / Impedance

PHONO (MM) ................................................ 4.0 mV / 47 k

CD1 ................................................................. 300 mV / 47 k

DVD/6CH. ....................................................... 300 mV / 47 k

Output Level / Impedance

TAPE REC ..................................................... 300 mV / 2.2 k

PRE OUT (Front, Center, Surround, Surround back)

................................................................................ 1 V / 470

PRE OUT (Subwoofer) ....................................... 1.8 V / 470

Tone Control

Bass ............................................................ + 7 dB (at 100 Hz)
Treble ......................................................... + 7 dB (at 10 kHz)

Loudness Control

Volume at -30 dB level ....... +6 dB (100 Hz), +3 dB (10 kHz)

Digital Audio Section

Sampling Frequency ............. 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input Level / Impedance / Wavelength

Optical ........................ -15 dBm ~ -21 dBm, 660 nm +30 nm
Coaxial ............................................................ 0.5 Vp-p / 75

Output Level / Impedance / Wavelength

Optical ........................ -15 dBm ~ -21 dBm, 660 nm +30 nm
Coaxial ............................................................ 0.5 Vp-p / 75

Warnings

FCC WARNING
This equipment may generate or use radio frequency en-
ergy. Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly
approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized
change or modification is made.

NOTE: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in
a residential installation. This equipment may cause harm-
ful interference to radio communications if it is not installed
and used in accordance with the instructions. However, there
is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the
receiver.

Connect the equipment into an outlet on a circuit dif-
ferent from the one that the receiver is connected to.

Consult the dealer or an experienced radio/TV techni-
cian for help.

FCC Compliance Notice
Audio-video Receiver, VR-5700, VR-5090 and VR-5080, and
Remote Controller, RC-R0913

These devices comply with Part 15 of FCC Rules.

Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.

KENWOOD U.S.A. CORPORATION

2201 East Dominguez St., Long Beach, CA 90801-5745

Telephone: 310-639-9000

IC(Industry Canada) Notice
Operation is subject to the following two conditions: (1)
This device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.

Note to CATV System Installer:
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC that provides guide-
lines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry as
practical.

NOTE: Do not use contact cleaning agents because they
could cause a malfunction. Be especially careful not to use
contact cleaning agents containing oil, since they may de-
form the plastic components.

Kenwood follows a policy of continuous advancements in
development. For this reason, specifications may be changed
without notice.
Full performance may not be exhibited in extremely cold
locations (below 0 deg. C).

Advertising
This manual is related to the following products: