Kenwood KTC-D500E - Manual (Page 13)

English 13
System Setup
Set the behavior of this unit such as the display
language and aspect ratio.
The following items can be set:
OSD Language User could select the desired language.
TV Aspect Ratio
This function provides 4:3 and 16:9 two ratio
for user to select. If your display supports 16:9
screen format and selected channel provides
16:9 format program, select 16:9.
TV Screen Format
There are four screen format could be selected,
Full, Pan&Scan, Letter Box, and Combined.
Auto Switching
Interval
User could set the auto switching interval time
from OFF to 30 Seconds when the box cannot
receive the video signal. User also could use the
[A] to [Z] key on the RCU to switch the signal
immediately.
TV Type
Select the TV signal type (PAL or NTSC)
according to the display.
0/5 Volt
Set "0/5 Volt" ON when connecting an antenna
with booster amplifier to this unit.
Power On Option
This function provide user to select the unit at a
power on mode or a stand by mode. If the user
select the unit at power on mode, when user
turn on the car, then the unit will be turned on
at the same time.
Volume Rate Control
If user connect to an amplifier, user could use
the volume rate to control the volume. There
are 18 levels could be selected.
⁄
• Depending on the country where you buy your receiver,
some functions might not be available in this menu.
• If you changed the "0/5 Volt" setting, perform Auto Scan.
1 Show DVB Menu by pressing [MENU] key
2 Touch [ 5] or [∞], select [Setup]
3 Touch [ 3]
4 Touch [ 5] or [∞], select [System Setting]
5 Touch [Enter] ( )
System Setup Menu appears.
6 Touch [ 5] or [∞] to select the item to set
7 Touch [ 2] or [3] to select the value to set
8 Touch [Return] ( ) when you are finished
Setting this unit's behavior and clock.
Setup