Kawasaki P9723 - Manual (Page 11)

11 P9723pr-0920
• Fit the front clip onto the front of the vehicle, as shown.
Hint: The front clip may be factory assembled.
Front Clip
FRONT VIEW 13
• “Snap” a hubcap onto the center of each wheel cover.
• Turn the vehicle upright.
12
• Slide a 7 /
16
" washer onto the front axle.
• Slide a bushing, ring end first, onto the front axle.
• Locate a front wheel. Slide the wheel, flat side first, onto the
front axle.
• Slide a wheel cover, indented side out, onto the front axle.
• Repeat this procedure on the other side of the vehicle.
Front Axle
10
11
Washer
Bushing
(Ring End First)
Front Wheel
(Flat Side First)
Wheel Cover
(Indented Side Out)
Hubcaps
Hubcaps
SIDE VIEW
BOTTOM VIEW
• Fit a 3 /
8
" -16 hex nut onto each end of the front axle. Tighten
both hex nuts with the wrench.
Wrench
3 /
8
" -16 Hex Nut