Kawasaki P9723 - Manual (Page 9)

9 P9723pr-0920
• Slide a wheel cover, indented side down, onto the rear axle.
• Locate a rear wheel. Slide the wheel, indented side down,
onto the rear axle.
• Slide a rear wheel driver, slotted side down, onto the rear axle.
Fit the slots on the rear wheel driver onto the pegs on
the wheel.
2
Rear Wheel Driver
(Slotted Side Down)
Wheel Cover
(Indented Side Down)
Rear Wheel
(Indented Side Down)
• Position the vehicle upside down.
• Slide the rear axle assembly through the hole in the back end
of the vehicle, as shown. Make sure the rear wheel driver fits
into the pins in the motor assembly inside the vehicle.
3
Rear Axle Assembly
• Slide a rear wheel driver, slotted side out, onto the rear axle.
Make sure the rear wheel driver fits into the pins in the motor
assembly inside the vehicle.
• Locate the other rear wheel. Slide the wheel, flat side first,
onto the rear axle. Make sure the slots on the rear wheel
driver fit onto the pegs on the wheel.
• Slide a wheel cover, indented side out, onto the rear axle.
Rear Wheel
(Pegged Side First)
BOTTOM VIEW
Rear Wheel Driver
(Slotted Side Out)
Wheel Cover
(Indented Side Out)
Motor Assembly
• Fit a 3 /
8
" -16 hex nut onto the end of the rear wheel assembly.
• Completely tighten the hex nuts on both sides of the rear
wheel assembly with the wrench.
Hint: An extra wrench has been provided to hold the hex nut
on one side of the rear axle while tightening the hex nut on
the other side.
5
Motor Assembly
4
Wrench
3 /
8
" -16 Hex Nut