Kompernass KH 2360 - Manual (Page 11)

- 9 -
5.3 Preparing the remote control
Inserting the battery
The remote control requires a battery of the type
CR2025/3V button cell (supplied):
1. Pull the battery compartment out of the remote
control.
2. Now place the supplied battery, of the type
CR2025 (button cell) in the battery compart-
ment. Make sure that the battery is inserted in
accordance with its correct polarity.
3. Slide the battery compartment back into the
remote control.
Using the remote control
In order to guarantee faultless operation when using
the remote control…
• When using the remote control always point it di-
rectly at the infrared sensor 4( on the front panel
of the device.
• Make sure that there are no obstructions between
the remote control and the DVD player that will
hinder reception
• When using the remote control place yourself not
more than 5 metres from the DVD player
otherwise interferences can occur during operation
of the DVD player functions with the remote control.
6. Attaching the LCD
monitor to a headrest
For attachment to the headrest use exclusively the
supplied Velcro fastening strap and pad.
1. Remove the pad from the Velcro fastening
strap.
2. Pull the Velcro fastening strap, with the Velcro
side towards the rear, through the right retainer
on the rear of the LCD monitor. Please do not
pull the strap through the left retainer at this
time.
3. Pull the open end of the strap through the pad.
The unpaded side must be facing the device.
4. Finally, pull the strap through the left retainer.
The plastic tab should now point to the right.
IB_KH2360_V5256_UK.qxd 31.08.2007 13:49 Uhr Seite 9