Kenwood KDV-5234 - Manual (Page 52)

52 KDV-5234
Menu
Setting security code
Sets a security code to prevent theft.
• Before setting a security code, turn off the demonstration
mode. For further information, refer to <Demonstration
setup> (page 53).
• When you activate the Security Code function, it cannot
be released.
Note, your Security Code is the 4-digit number entered in
your "Car Audio Passport" in this package.
1 Set to the menu mode
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
SRC
MENU
2 Select the security code set feature
CODE SET
3 Start security code setting
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
ENTER CODE : ––––
4 Enter a security code
Select the digit to enter.
Select a number to enter.
5
Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
RE-ENTER CODE : ––––
6 Repeat the entry
Using the same method as in the step 4, enter
the same security code.
7 Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
APPROVED
8 Exit the security code setting
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
SRC
• If the security code entered in step 6 is different from the
code entered in step 4, you must repeat the procedure
from step 4.
• Once the security code has been set, the code needs to
be entered every time the reset button is pressed or the
battery is disconnected. For further information, refer to
<Security code entry> (page 53).
• The security code can be set in the STANDBY state. For
the basic method of how to operate the menu, refer to
<Menu setup> (page 50).