Connect water supply line and drain hoses – KITCHENAID W10216167A User Manual
Page 10
10
Option 1: Right-hand side utility access
■
For right-hand routing, drain hoses are shipped in the correct
position. Place the water supply line in the clip as shown.
Option 2: Left-hand side utility access
■
For left-hand routing, remove drain hoses from the clips in the
rear bracket as shown.
■
Route water supply line and drain hoses into the cabinet.
■
Slide dishwasher partway into the cabinet opening. Allow for
access to the electrical terminal box.
Connect Water Supply Line and Drain
Hoses
1. Connect water supply line to the water valve under the sink.
2. Slide clamps onto drain hoses (Figure A). Do not cut drain
hoses.
3. Push hoses into Y drain connector until fully seated (Figure B).
Several “clicks” will be heard.
4. Slide clamps into position (figures C and D).
A. Hot water supply
A
A
B
C
D