Kawasaki 1600 - Manual (Page 17)

ASSEMBLY 15
Front Footboard (Left)
NOTE
ż Install the left footboard after the “Clutch Fluid”
section in the Preparation chapter.
•
Install the left footboard assembly on the
frame with one bolt (D = 10, L = 30) at the
rear and tighten it.
A. Front Footboard (Left)
B. Bolt (Rear)
NOTE
ż The bolt in front is for tightening the footboard
and the front guard together.
ż Tighten the front footboard mounting bolts af-
ter installing the front guards to the specified
torque.
Front Guards (Left and Right)
Front Guards Installation
•
Remove the front side mounting bolt from the
front right footboard.
A. Front Footboard (Right)
B. Bolt
•
Install both front left and right guards on the
frame with the upper mounting bolts (D = 10,
L = 25), and on the front footboard brackets
with the lower mounting bolts (D = 10, L = 30).
A. Front Guard (Left)
B. Bolt (D = 10, L = 25)
C. Bolt (D = 10, L = 30)
D. Footboard Bracket
•
Tighten the front footboard and the guard
mounting bolts to the specified torque.
Torque : 34 N·m (3.5 kgf·m, 25 ft·lb)
Label Installation (for US and CN Mod-
els only)
•
Wipe off any oil or grease from the application
area.
•
Peel the warning label off the backing sheet
and stick it on the center of the front left guard.
A. Front Guard (Left)
B. Label For US Models (56070-1285)
C. Label Top
D. Label For CN Models (56070-1180)