Kingston Technology Bay Networks 2000 - Manual (Page 50)

Changing Hardware Configurations 44
Installing Option Cards
The following illustration shows you how install LAN or WAN option cards into the
Switch. You can use Slots 1 to 3 for any mix of LAN and WAN cards. Note that Slot 4
is not supported.
Figure 19
−
Installing LAN or WAN Cards
1. Power off the Switch.
2. Remove the filler panel screw and pull out the filler panel.
3. Slide the option card into the intended slot. Make sure the card seats
firmly and evenly into the card slot. If the card is not seated properly,
it will not work.