Kenwood KNA-DV3200 - Manual (Page 26)

26 English
English
Route Options
Route Preferences
The function allows settings to be made for the roads to be used and to start route calculation.
1 Each time a button is selected it will toggle between usage
and non-usage of the corresponding roads or ferries.
2 Select .
• can be selected during route guidance.
• The route will not necessarily follow the specified conditions.
Destination & Way Points
The destination or way points used in route calculation can be changed using this function.
■ Addition of way points
The following procedure can be used to add new way points to the current route for calculation.
1 Select .
2 Set the way point using your preferred method.
When a new destination is set by (Destination), it will replace
the current destination and route calculation will be carried out once
again.
3 When the required way points have been setup, indicate
the order in which they are to be visited.
Choose the location to be added, and then select .
4 Select .
• When a new destination is set by (Destination), it will replace the current destination and route calculation
will be carried out once again.
• Step 3 is required when setting the 2nd way point and more after.
• Repeat step 1 and 3 until all desired way points have been set.
3 (Route Options) 3 (Route Pref.)
Before Steps
3 (Route Options) 3 (Dest. & Way Pt.)
Before Steps
KNA-DV3200(E)_ENG r2.1 04.7.23 4:32 PM Page 26