Kawasaki PVS2970S - Manual (Page 27)

E - 26
SYMPTOM CAUSE (AND REMEDY)
• The region number of the disc doesn't match the region number of this unit.
• Clean the disc.
• The disc is scratched. The picture is not
clear.
No picture.
• Make sure that you've select DVD mode.
• The system is in pause mode. Press the PLAY button to return to normal play mode.
• Fast forward or fast reverse is performed. Press the PLAY button to return to normal play
mode.
• Make sure that AUDIO / VIDEO output and AV IN input connections are correct.
• The DTS DVD disc cannot be decoded to have speaker output.
• This unit is too hot, shut off the unit for 30 minutes to cool down.
The remote does
not function.
• Check that the AC cord and AC adpater or the Car plug adapter are connected.
• You did not turn on the unit. No power.
DVD
No sound or only
a very low-level
sound is heard.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
• Clean the disc.
• There is no disc inside ("No Disc" appears on the screen).
• Insert the disc correctly with the playback side facing forward.
• Clean the disc.
• A non-NTSC disc has been inserted. The unit and disc region number are incompatible.
• Condensation may have formed inside the unit due to a sudden change in temperature. Wait
about an hour for it to clear and try again.
The disc does not
play.
Severe hum or
noise is heard.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the battery in the remote with new one.
TROUBLE SHOOTING GUIDE
NOTICE: Kawasaki is trademark licensed by Kawasaki Motors Corp., U.S.A. However, this product
is neither manufactured nor distributed by Kawasaki Motors Corp., USA.
Consumer inquiries should be directed to Alco Electronics at 1-800-252-6123.