Kompernass Victoria 270 E - Manual (Page 13)

13
b) Changing the sew foot
First raise the needle fully, by turning
the handwheel.
ᕡ Loosen the foot screw and take off
the sew foot together with the foot
holder.
ᕢ Press the lever on the foot holder.
The sew foot can now be separated
from the holder.
ᕣ Place the selected sew foot on the
holder, for example the
ả buttonhole foot
Ạ blind hem foot
Ấ button foot
Ả zipper foot
ᕢ and press the lever again till the sew
foot engages in the holder.
ᕡ Place the sew foot and holder back
on the guide rod and tighten the foot
screw again.
c) Changing the stitch plate
The zigzag stitch plate is mounted on
the machine at the factory, and can be
used for most straight stitches, zigzag
stitch work, and decorative stitches.
However, if you wish to use the darning
plate supplied:
First raise the needle fully, by turning
the handwheel.
ᕤ Simply lay the darning plate on top
of the zigzag plate, so that the flat
guide pins are inserted in the slots in
the zigzag plate.
• If you no longer need the darning
plate, simply take it off again.
³
»
·
¿
IB_Sewingmachine_content_UK.qxd 22.07.2004 12:21 Uhr Seite 13