KVH Industries TracVision S3 - Manual (Page 18)

2-7
Installation
54-0157 Rev. G
13. Remove the nuts and washers securing the
shipping restraints to the baseplate. The positions
of all three shipping restraints are pictured in
Figure 2-8.
14. For convenient storage, rotate the shipping
restraints 180 º and secure them to their original
mounting bolts using the nuts and washers
removed in Step 13 (see Figures 2-9 through 2-11).
All nuts and washers removed in Step 13 must
be reinstalled. These nuts and washers secure the
baseplate to the mounting plates.
Installation Bolt and Washer
Rotating Plate Shipping Restraint (1 of 2)
Figure 2-10
Rotating Plate Shipping
Restraint Storage
Rotating Plate
Shipping Restraint
Rotating Plate
Shipping Restraint
Forward Shipping
Restraint for
LNB Bracket
Figure 2-8
TracVision L3/S3 Shipping
Restraints (Top View,
Installed for Shipping)
Do not discard the shipping
restraints, washers, or the nuts.
They should be stowed for future
use in case the antenna unit needs
to be removed and shipped to
another location. Four
1 ⁄
4
˝ x 5 ⁄
8
˝ hex
head screws have been provided in
the kitpack for shipping as the bolts
used to hold the shipping restraints
during initial shipping are integral
parts of the mounting plates.
Forward Shipping Restraint
Installation Bolts and Washers
LNB
Figure 2-9
Forward Shipping
Restraint Storage