KVH Industries TracVision S3 - Manual (Page 40)

3. Turn on the antenna using the switchplate, as
pictured in Figure 3-2.
4. (TracVision L3 only) If the vehicle is moving, avoid
turning the vehicle for 60 seconds after turning on
the antenna to allow the antenna gyro to initialize
properly.
3.2 Changing Channels and
Switching Between Satellites
If you have followed the installation instructions, your system
should be set to the active satellite pair of your choice and the
system should have downloaded the appropriate channel guides.
You must also have a properly configured IRD (if this has not
been done, refer to your IRD User’s Manual for instructions for
your specific IRD).
Your TracVision system is programmed to track either of two
satellites, stored in memory as Satellite A and Satellite B. You can
use the IRD remote control, the optional TV/SAT Switch, or a PC
to select between the two satellites.
3.2.1 Using the IRD Remote Control to Switch
Between Satellites
When the TracVision L3/S3 system and the IRD have matching
configurations, switching from one satellite to the other is as easy
as changing the channel using the remote control. TracVision
L3/S3 will automatically switch from Satellite A to B and back
again as necessary to receive your selected channel.
DIRECTV Satellite Subscribers
DIRECTV subscribers in certain regions of the United States will
require a DSS Plus IRD to receive both satellite and alternative
programming. Check with DIRECTV for regional requirements.
If connected to the antenna’s RF1 connector, the DSS Plus IRD
allows you to switch channels using the remote control. If you
are a DIRECTV subscriber, but do not have a DSS Plus IRD, or
you are using a multiswitch, use the optional TV/SAT Switch* or
a PC, as described in the following sections.
* To order a TV/SAT Switch (KVH Part Number 01-0245), please call +1 401 847-3327.
3-2
A Guide to TracVision L3/S3
The satellite configuration on
your IRD must match the satellite
setting on the TracVision L3/S3
system.
Satellite A on the TracVision L3/S3
must be the same satellite as IRD
Alternative 1 (or A, based on your
IRD) and must be assigned the IRD
DiSEqC 1 setting.*
Satellite B on the TracVision L3/S3
must be the same satellite as IRD
Alternative 2 (or B, based on your
IRD) and must be assigned the IRD
DiSEqC 2 setting.*
Refer to your IRD user manual for
complete instructions for your IRD.
* DiSEqC applies to European systems only
If you are a DISH 500 customer,
you can order the optional TV/SAT
Switch – free of charge. Simply fill
out the order form located at the
back of this manual and fax it to
KVH at +1 401 845-8190.
Antenna
On/Off
Switch
Figure 3-2
Turning on the TracVision L3/S3
Using the Switchplate