KORG PXR4 - Manual (Page 81)

Effect parameters
79
B WahDwn (BASS WAH DOWN)
This is a wah in which the filter operates in the opposite direc-
tion from BASS WAH UP.
* The parameters are the same as “BASS WAH UP.”
Filter1 (FILTER1)
This is a band pass filter with a fixed frequency.
It is placed before the drive block.
1. FREQENCY........... [1...10]: Adjusts the center frequency of the fil-
ter.
2. -----(BLANK)......................
3. -----(BLANK)......................
4. -----(BLANK)......................
5. -----(BLANK)......................
Filter2 (FILTER2)
This is a low pass filter with a fixed frequency.
1. FREQUENCY ....... [1...10]: Adjusts the center frequency of the fil-
ter.
2. PEAK ..................... [1...10]: Adjusts the curve of the filter.
3. -----(BLANK)......................
4. -----(BLANK)......................
5. -----(BLANK)......................
SlowAtk (SLOW ATTACK)
This slows the attack of each picked note, producing a violin-
like effect.
1. ATTACK ................ [1...10]: Adjusts the time over which the vol-
ume rises.
2. THRESHOLD ....... [1...10]: Adjusts the level at which the effect
applies.
3. -----(BLANK)......................
4. -----(BLANK)......................
5. -----(BLANK)......................
AMBIENCE BLOCK
1. DELAY
Delay (MONO DELAY)
This is a mono delay with a maximum delay time of 2.0 sec-
onds.
1. TIME ....................... [0...2s]: Adjusts the delay time.
2. FEEDBACK ...........[0...10]: Adjusts the feedback (delay repeats).
3. TONE...................... [0...10]: Adjusts the tone of the delayed
sound.
4. -----(BLANK) .....................
5. MIX ......................... [0...10]: Adjusts the mix amount of the
delayed sound.
2. AMBIENCE
Echo (ECHO)
This effect simulates a tape echo unit.
1. TIME ....................... [1...10]: Adjusts the delay time.
2. FEEDBACK ...........[0...10]: Adjusts the feedback (delay repeats).
3. TONE...................... [0...10]: Adjusts the tone of the echo.
4. -----(BLANK) .....................
5. MIX ......................... [0...10]: Adjusts the mix amount of the echo.
StDelay (STEREO DELAY)
This is a stereo delay with a maximum delay time of 1.0 sec-
ond (for CHAIN5) or 1.75 seconds (for CHAIN8).
1. TIME ....................... [0...1s]: Adjusts the delay time.
............................ [0...1.75s]: *For CHAIN8
2. FEEDBACK ...........[0...10]: Adjusts the feedback (delay repeats).
3. TONE...................... [0...10]: Adjusts the tone of the delayed
sound.
4. SPREAD .................[0...10]: Adjusts the left/right spread of the
sound.
5. MIX ......................... [0...10]: Adjusts the mix amount of the
delayed sound.