KWC SUPRIMO Z.534.171.000 - Manual

The Standard KWC Product
Warranty applies.
Keep this leaflet for
future reference.
KWC FAUCETS INC.
1770 CORPORATE Dr.#580
NORCROSS,
GEORGIA 30093
USA
Tel: 678-334-2121.
Fax: 678-334-2128.
KWC AG.
CH-5726
UNTERKLUM,
SWITZERLAND.
Tel: 062-768-68-68.
Fax: 062-768-61-62.
SUPRIMO
LIQUID SOAP AND
LOTION DISPENSER
Z.534.171.000 – CHROME
Z.534.171.121–BRUSHED NICKEL
Z.534.171.700–STAINLESS STEEL
Z.534.171.734-SS/BLUE
Z.534.171.736-SS/MATT-BLACK
AN HYGIENIC AND ATTRACTIVE
DISPENSER FOR SINKS, LAVATORIES AND
COUNTERTOPS. IT IS EASILY INSTALLED
WITH CONVENIENT TOP FILL.
Patent Applied For
Installation Instructions
1. Either use an existing hole in the sink, lavatory or countertop, or prepare one specially. It should
have a diameter between 25mm and 35mm (1” and 1 3/8”). The center of the hole should not be
more than 100mm (4”) from the inside edge of the sink. The maximum thickness of the surface
should not exceed 50mm (2”).
2. Pass the CONNECTOR down through the hole from above with the WASHER immediately above
the surface. Screw the NUT onto the CONNECTOR beneath the surface and tighten – hand tight is
sufficient. If sink or countertop is not sufficiently thick to allow NUT to tighten, use large spacer
washer provided positioned between NUT and underside of surface.
3. Connect the bottle onto the lower end of the CONNECTOR by passing the 4 lugs inside the bottle
neck. Push the BOTTLE firmly upwards until it clicks into position.
4. The PUMP UNIT will already be assembled within the BODY. Push the TUBE into the lower end of
the PUMP.
5. Fill the BOTTLE through the CONNECTOR as shown below (a) (the BOTTLE holds 15 fl. Oz. And
should not be overfilled), then place the assembled BODY,PUMP UNIT and TUBE into the
CONNECTOR as shown below (b).
a)
Fill the bottle through the connector. (b) Insert the body, pump unit and tube.