Konica Minolta X50 - Manual (Page 37)

37
DRIVE MODES
The drive modes control the rate and method
images are captured. Indicators indicating the
selected drive mode appear on the monitor. If
auto reset (p. 45) is active, the drive mode is reset
to single-frame advance when the camera is
turned off.
Press the down key of the controller to select the
drive mode (1).
1
Single-frame advance - to take a single image each time the shutter-release
button is pressed. This is the camera’s default setting.
Self-timer - to delay the release of the shutter (p. 38). Used for self-portraits.
Multi Frame - to create a composite image of a nine-frame series when the
shutter-release button is pressed once, see below.
Continuous advance - to take up to four images when the shutter-release
button is pressed and held (p. 39).
UHS continuous advance - to take eleven 1280x960 size images in one
second when the shutter-release button is pressed and held (p. 39).
Multi Frame
Take the picture as described in the basic recording
operation section (p. 24). Once the series starts, the shutter
button can be released; the camera continues recording
until all nine frames have been captured.
Flash cannot be used. Because of the limits to the shutter
speeds, images may be underexposed in low-light
conditions. Image size refers to the total area of all nine
images, not the size of each individual thumbnail.