Kyocera FS-1200 - Manual (Page 26)

1.4. Setting Up and Interfacing
1-7
1.4. Setting Up and Interfacing
Before you can use the printer for the first time, you must set up the printer by installing the printer compo-
nents and interfacing with the computer. Follow the steps that follow. (Omit step 7 if you do not have an
optional face-up output tray.)
1—Open the top cover
1. Remove the packing tape from the printer.
2. Open the printer top cover all the way.
2—Install the toner container
1. Take the toner container.
2. With the label side down, thoroughly shake the toner
container (in the direction of the arrow) ten times or
more to loosen and mix the toner inside.
3. The bottom of the toner container is sealed with a
sealing strip. Peel off the seal on the toner container
and carefully pull off and dispose of the sealing strip.
☛
Be sure to peel the seal off the toner container
before the toner container is fitted into the devel-
oper unit.
4. Install the toner container on the developer
as show in the diagram.
Top Cover
Toner Container
Sealing Strip
Developer Unit