Kyocera FS-1200 - Manual (Page 57)

2.4. Configuring Interfaces
2-13
2.4. Configuring Interfaces
The printer is equipped with a parallel interface. An optional serial interface is also available.
To configure each interface, press the MODE key and use the + or – key to select the interface you wish to make
settings for.
☛
This interface selection does not select which interface data will be received from. The printer auto-
matically selects that interface.
Parallel Interface
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally, this inter-
face is used under the default setting
ý$XWR, see Appendix C. After setting the interface, be sure to reset the
printer or turn the power off at least once. The new setting will be enabled thereafter.