KORG DSD MR-1000 - Manual (Page 39)

39
DSD output filter settings (DSD Filter)
If you turn this setting on, the sound when playing a 1-bit project/file will pass through the
signal processing filter. By default, this is "ON".
ON: Playback will pass through the DSD filter (-3.0 dB at the pass frequency of 50 kHz).
OFF: The 1-bit signal will play back directly without going through the DSD filter.
Noise or extraneous sound may occur if you connect this to a device that does not support wideband
audio input. Before turning this setting off, you must check the owner's manual of the connected
device.
1. Press the menu button, and from the menu list (MENU) screen, use the P-dial to se-
lect and confirm "SYSTEM."
The system setting (SYSTEM) screen will appear.
2. Use the P-dial to select and confirm "DSDFilter".
The selection icon will change from " " to " ", and the value of the setting will be high-
lighted.
Push
Push Push
3. Turn the P-dial to select "OFF".
If you want to turn the setting on, select "ON" in the same way.
4. Press the P-dial (or the menu button) to complete the setting.
The selection icon will change from " " to " ".
Text3_E.p65 06.11.28, 10:27 AM 39