Kathrein UFD 580 - Manual (Page 10)

Important Note on Initial Operation of the Receiver on a
UFO®micro System
10
Important Note on Initial Operation of the Receiver on a UFO ® micro System
It is absolutely essential to carry out the following before and while registering receivers on the EXU 544
UFO
® micro single-cable matrix:
- Connect the receiver to the TV set, but do not yet connect it to the UFO ® micro ESU 32 outlet!
- You must first check the following settings on the “LNB Configuration” menu and
change them as necessary:
1. Press the

button to switch to the main menu
2. Press

to get to the installation menu and confirm your entry by pressing

3. Press

to get to the LNB configuration menu and confirm your entry by pressing

4. Press

to select the “ASTRA” satellite and confirm your entry by pressing

5. Press

to select “Tuner input” and press

to change the selection to "#1 & #2“
6. Press

to quit the set-up for the “ASTRA” satellite
You must run through steps 4-6 for each satellite received!
7. Press

three times to get back to the start screen
8. Interconnect the “LNB1 LOOP OUT” tuner output and the “LNB2 IN” tuner input by a coaxial
cable (F standard connector).
- Now carry out a UFO ® micro reset on the receiver, as described below:
1. Press the

button to switch to the main menu
2. Press

to get to the installation menu and confirm your entry by pressing

3. Press

to get to the DiSEqC[UFO] set-up and confirm your entry by pressing

4. Press

to select the UFO option
5. On the UFO menu press

to select “UFO ® micro”
6. Press

and change your selection to RESET by pressing

Confirm your selection by pressing

7. Press

to quit the UFO menu (press

to save your changes)
8. Press

three times to get back to the starting point
- Press

to switch the receiver to standby mode
- Now you can connect the receiver to the ESU 32 outlet
- Press

to switch the receiver on
- The registration is then performed automatically – the screen briefly shows: “UFO ® micro active”
- Now perform a UFO ® micro reset as described above (items 1-8).