Kathrein UFD 580 - Manual (Page 53)

Audio Settings
53
Audio Settings
Setting the Volume
Set the required volume level by pressing the

button on the remote
control of the receiver. A bar indicator is displayed on the screen to
show the set volume.
Muting
Press

to mute the sound. A red bar indicator appears.
Press the button again to restore the sound.
Stereo and Two-Channel Sound Playback
Use the yellow

button to open the Audio menu for sound and
language selection, where you can make the desired settings, e.g.
subtitles, language selection (soundtrack), audio mode, digital output
(MPEG stereo, AC 3), as long as they are included in the reception
signal:
Select the menu options using the

buttons and make the
desired setting using the

buttons. Press the yellow

button
again to exit the menu.
Possible audio settings include:
Soundtrack
1 of 2 2 of 2
Audio mode Stereo Mono left or right
Digital Output MPEG stereo Dolby Digital/AC 3
AC 3
The receiver has an electrical/optical audio output for AC3 format
(Dolby Digital). This gives you the opportunity to bring cinema quality
sound into your living room. The AC 3 sound is recorded and can be
selected during playback. Connect the corresponding digital audio
output to a Dolby Digital system.
If no AC3 signal is received, you can only make the normal stereo or
mono settings, and choose the broadcast languages.
Be sure to follow the
instructions in the
manual for your Dolby
Digital system.