Kodak i1800 Series - Manual (Page 81)

5-16 A-61555 March 2007
4. Push down on the release lever (located underneath the printer
access cover) to release and remove the feed module.
5. If you are just replacing the feed module, do the following. If you are
replacing the tires, go to Step 6.
• Insert the new feed module by aligning the pins, fitting it into
position and pulling up on the release lever to lock it into place.
Verify that the feed module is securely in place and moves freely
after you install it.
• Close the pod and the printer access cover.
• Reinstall the output tray.
Align
these
areas