Ab c, Installation – Kenwood LZ-702W User Manual
Page 14
14
|
English
Installation
Installation for Monitor Unit
Installation location and cleaning
Select for installation a location where the stand
can be placed completely horizontal or where the
front edge of the support (petal-shaped part) can
be attached horizontally as shown in Figure A.
Do not install in locations where the entire support
is at a diagonal such as in Figure B or where the
monitor unit is facing down such as in Figure C.
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
A
B
C
• Thoroughly wipe away and dust or grease from the
installation location using a cloth which has been soaked
in a neutral cleaning agent and wrung out. Attach the
stand after allowing the installation location to dry.
Installation for Monitor Unit
1
Install the shoe on the rear of the TV monitor
temporarily using the supplied hexagon wrench
(Accessary
5).
• When adjusting the fixing screw of the shoe, use the
hexagon wrench (Accessary
5) that came with the
product. Using other hexagon wrenches may damage
the screw.
2
Bend the stand support to conform to the shape
of the installation location.
3
Adjust the shape of the support so that there is
no rattling or gap when the stand is placed on
the support.
4
Peel off the protective strip from the double-
sided tape on the bottom of the stand and
securely attach the stand.
• Do not attach the double-sided tape more than once or
touch the adhesive with your fingers as this will weaken
its adhesive strength.
• If the temperature of the surface of the installation
location is low, warm it up using a heater or other means
before attaching the stand. Low temperature may
weaken the adhesive strength of the tape.
• The supplied stand is specially intended for this product.
Do not use it with another monitor.
5
Secure the stand using the supplied tapping
screw (Accessory
4).
6
After attaching the stand, allow it to sit
undisturbed for 24 hours. Take care not to apply
any force to the stand during this time.
7
Insert the shoe of the monitor unit into the
bracket (Accessory
3).
• Insert the shoe into the bracket (Accessory
3) as far as it
goes. (Fig. 1)
8
Adjust the height, horizontal and vertical angle
of the monitor unit, and securely tighten the
installation screws using the supplied hexagon
wrench (Accessary
5).
You can also adjust the monitor unit's forward
position by loosening the angle adjustment
knobs and adjusting the angle of the monitor
unit's installation stand.
Accessory
3
Accessory
4
Protective strip
Installation surface
Accessory
5
Shoe
Accessory
5
Tighten
Loosen
Fig. 1