Allenair valve installation – Keiser 1031 User Manual

Page 6

Advertising
background image

10-5508 Rev A Service Department (800) 888-7009

6

push on board, pull on wire

Pull each of the four wires back out the hole one by one. Save the rubber
grommet.

There are four steps to Allenair® valve installation:

1 Adjust and mount new valve
2 Install single to double splitter and electrical wires
3 Secure and tie wires and replace lid

4

Test compressor

5

Note: Keep two things in mind when you are ready to install the new valves.

First, the new valve requires a different mount. Second, the electrical wiring requires the

installation of a single to double adapter on the circuit board.

Advertising
This manual is related to the following products: