KORG TONEWORKS AX5G - Manual (Page 10)

10
If the expression pedal’s control target is FX PARAM, changing the cat-
egory of the effect controlled by the pedal will reset the pedal control
target to the most useful parameter of the selected effect. (p.50 “Param-
eter List”)
If you set the expression pedal’s control target to FX PARAM, the corre-
sponding effect will automatically be turned On. If, in this state, you op-
erate the pedal or press the pedal setting switch once to select VOLUME
without editing the setting, the effect will automatically be turned Off again.
However, if you did operate the pedal or edit the setting, the effect will
remain On even if you press the pedal setting switch once again to se-
lect VOLUME as the target.
If the expression pedal’s control target is WAH, you can turn the function
select knob to [PRE FX] (the display will indicate “
”) or [PRE FX-
PARAM] and edit the WAH parameters. When the expression pedal’s
control target is WAH, changing the [PRE FX] effect type will switch the
expression pedal’s control target to VOLUME.
Saving a program (Write mode)
Here’s how to save (write) a sound that you’ve created.
If you switch to a different program in Program mode or turn off the power
without writing your settings into memory, the changes you made will be
lost.
1. Set the function selector to [WRITE].
2. Press the [ ▲ (WRITE)] button. The program number will blink.
3. Use the value knob or the program up/down switches to select the
program in which you want to save your settings.
4. Press the [ ▲ (WRITE)] button once again. The program will be saved,
and the program/value display will indicate “ ”(Complete) briefly.
The newly saved program will overwrite (i.e., replace) the existing
settings, so that the previous program in that location will be lost.
If you decide not to save the new program, press the [CANCEL] but-
ton to cancel the operation.
Checking the values saved in a program (Original Value)
In Edit mode, the original value LED in
the program/value display indicates the
parameter value that is saved in the
program.
When you use the knob or switches to
modify the value of a parameter, the
Original Value LED will light when that
value matches the value that’s already
been saved in the program (i.e., the
original value).
The original value LED won’t
light in Program mode.
Bypass and Mute
Bypass (which turns off all effects including noise reduction) and Mute
(which mutes the AX5Gs output) are convenient functions for use while
you’re adjusting your guitar amp, tuning during a live performance, or
switching guitars. Here’s how to use Bypass or Mute.
Bypassing the AX5G
Simultaneously press the Program Up and Program Down switches; all
effects will be bypassed. At this time, the program/value display will indi-
cate “ ”.
Muting the AX5G
Simultaneously press and hold down the Program Up and Program Down
switches for about one second and the output will be muted. At this time,
the program/value display will indicate “ ”.
When bypassed or muted, the Auto Chromatic Tuner will be active. To
cancel the bypass or mute function, press the Program Up or Program
Down switch (this will not change the program). At this time the value
knob will operate as the master volume.