Kathrein MobiSet 3 CAP 310 - Manual (Page 10)

10
Safety instructions - important notes
Instructions for installation and operation of the HDP 171
with the UFD 170
1. The turntable can only be used in conjunction with a Kathrein
UFD 170 Caravan Digital Combi Receiver or a Kathrein UFD 540
Caravan Digital Receiver with HDS 160 control unit.
2. To ensure reliable functioning of the turntable, the power supply
cable must be connected directly to the battery. If the power supply
is too low, the receiver indicates this with the on-screen message
“On-board voltage too low!” or with “HDP overload” on the television
screen.
A fuse (15 A) is integrated into the power supply cable.
While driving, the antenna must always be lowered to the horizontal
position (park position).
To remind yourself of this, please use the stickers in the visual area
around your vehicle ignition switch.
Lowering the antenna while driving
During installation of the turntable, make sure that no persons, in
particular children, are in the immediate vicinity of the turntable and
that they do cannot touch any moving parts – danger of crushing!
Always unplug the power supply during installation work.
Safety precautions during installation
Cleaning the antenna
To clean the antenna, use only water and cleansing agents typically
used for vehicles.
Do not clean the equipment with steam jet or high-pressure washers.
Do not use any cleansing agents which contain solvents such
as acetone, nitro-cellulose combination thinner, naphtha, etc.
since this can damage individual components.