Kathrein MobiSet 3 CAP 310 - Manual (Page 28)

28
We strongly advise that users who are not familiar with
the installation work should not reassemble the BAS 60
independently. They should contact a technician or engineer.
They may fi nd a suitable person on the campsite.
Make sure that:
- The antenna and connected units are disconnected from the
power
- The person carrying out the installation does not suffer from
vertigo and can move around safely on the roof of the caravan or
motorhome
- The person carrying out the repairs is wearing sturdy and non-slip
shoes
- The person carrying out the repairs has a secure position to stand
and hold on while working
- The roof and the climbing equipment used (e.g. ladder) are dry,
clean and non-slip
- The roof can withstand the weight of the person carrying out the
repairs
Attention! Risk of death or injury due to falling or roof
collapse!
- No persons, especially small children, should be in the
immediate area of the turntable and touch movable parts during
dismantling/installation of the planar antenna. Nobody should
be below the antenna inside the caravan/motorhome during
dismantling/installation.
Attention! Risk of death or injury due to possible roof
collapse and falling parts on the motorhome/caravan.
Continue to heed the “safety instructions - important notes“
section!
No impediments may be in the turning range (see “safety
information - important notes”)!
The explanation of this installation process is based on the
assumption that the entire CAP unit has been properly put
together, installed and set up, as described in this installation
manual. The safety instructions in the detailed operating manual
for the UFD 170 must also be followed!
Polarisation setting
Safety notes
Installation process