Kathrein MobiSet 3 CAP 310 - Manual (Page 31)

31
Dismantling for servicing
If repairs to the system or individual components are necessary,
contact your specialist dealer or our service centre (see below for
address).
Never open the turntable yourself!
Dismantling
• The cables may not be cut!
• Disconnect the power, coaxial and data cables from the UFD 170
• Remove the sealing gasket from the roof duct (Fig. E)
• The cables laid inside the vehicle can remain there
• Unscrew the six M6 screws securing the turntable on the mounting
plate
• Place the turntable on the prepared support beams with the three
3.5 m long cable harnesses
• Carefully pull the three connecting cables out of the roof duct
• To ship the turntable, use the original packaging which you have
saved
• Seal the opening in the vehicle roof appropriately to protect against
penetrating moisture
Note: Before replacing the UFD 170 receiver, the turntable should fi rst
be moved to park position.
Address of the service centre
ESC
Electronic Service Chiemgau GmbH
Bahnhofstrasse 108
83224 Grassau, Germany
Phone: +49 8641 9545-0
Fax:
+49 8641 9545-35 and -36
Internet: http://www.esc-kathrein.de
E-mail: [email protected]