Kathrein UFS 712sw - Manual (Page 51)

51
Press the

button to move to the next selection item.
Transponder frequency
Use the

buttons or the keypad to select the transponder frequency on which the channel being
sought is transmitted. At the bottom right of the screen display, the receiver shows the current signal
strength and signal quality of the selected transponder.
Press the

button to move to the next selection item.
Service ID
Using the

buttons or the keypad, enter here the service ID of the channel being sought.
When you have made your settings, use the

buttons to select “Start Scan” and press the button
to start scanning. You can break off the scan prematurely at any time by pressing the

button.
During the scan you will see a display that shows you the progress of the scan.
After completion of the scan, you will see the following message (example):
Press the button. You will be asked whether you wish to save the changes or not. Selection is
performed using the

buttons and is confi rmed using the button. If you select “Yes, save changes”,
the newly found channels will be added to the end of the channel list. Then press the

button to exit
the menu. The channel list is called up on to the TV screen by pressing the button (see also section
“On-screen displays” “Channel list TV/Radio”).
CHANNEL SEARCH (CHANNEL SCAN)