Little Wonder 900 - Manual (Page 6)

OPERATION
1. Watch for hidden hazards when operating.
Roots, pipes, wire, sticks and holes can be
encountered quickly. Scout work area and
remove hazards before operating machine.
2. Before adjusting or servicing your BedShaper ® ,
wait for moving parts to come to a complete stop.
MAINTENANCE
1. Disconnect the spark plug wire before servic-
ing or adjusting your BedShaper
® to prevent
accidental starting.
2. Make sure all fasteners are tight and all shields
are in place and in good condition. Check blade
mounting nut frequently to make sure it is tight.
3. Make only the maintenance adjustments
described in this manual. Any unauthorized
adjustments or modifications to the BedShaper
®
may result in unsafe operating conditions.
4. Never alter or remove any safety devices on the
unit. Safety devices are incorporated into the
design for safe operation.
SAFETY AND INSTRUCTION DECALS
IMPORTANT
Safety and instruction decals are installed at the
factory. If any decals are missing, damaged or
illegible, replacements should be ordered and
installed immediately.
Before Operating, Follow Checklist Below:
• Perform a visual inspection.
• Inspect shields and safety equipment.
• Inspect blade drive belts for proper tension and
alignment.
• Check blade for secure mounting. Gloves
should be worn when handling blade- it may be
sharp enough to cause cuts.
• Adjust blade cutting height.
• Check blade engagement lever with engine run-
ning for proper operation. Blade should begin to
turn when handle is approx. 1
1 /
2
" (3.75 cm) from
being fully seated.
• Perform any maintenance items according to
maintenance chart on page 6.
Photo 3-1
3
❶ Warning Decal
❷ Danger Decal
➌ Underground Hazard Decal
❶
❷
➌
Little Wonder ®