Figure 5, Step 5 – Life Fitness CSLAT User Manual
Page 8
8
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
STEP 5:
FIGURE 5
• Insert the two GUIDE RODS (26) (found in the SHROUD KIT) into the base of the TOWER (1) as shown in FIGURE 5. Lubricate
the GUIDE RODS (26) with a slicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (16) down over the GUIDE RODS (26). See FIGURE 5.
• Using EXTREME CARE place twenty 10 LB. WEIGHT PLATES (24) over the GUIDE RODS (26) as shown in FIGURE 5.
(NOTE: If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (25) over the GUIDE RODS (26)
first, then slide ten 10 LB. WEIGHT PLATES (24) over the GUIDE RODS.)
• Carefully Slide the HEAD PLATE (8) down over the GUIDE RODS (26) onto the weight stack as shown in FIGURE 5.
• Slide one WEIGHT STACK SELECTOR PIN (15) over the shaft on the HEAD PLATE (8) as shown in FIGURE 5.
• Slide two GUIDE ROD BUSHINGS (20) over each GUIDE ROD (26).
• Slide two 1” SHAFT COLLARS (19) over each GUIDE ROD (26) as shown in FIGURE 5.
• Place the GUIDE ROD SUPPORT (6) over the GUIDE RODS (26) as shown in FIGURE 5.
16
24
26
8
15
19
20
6
1
25
HEAVY WEIGHT
OPTION
24
1A