Lennox Hearth COUNTRY COLLECTION 506033-35 - Manual (Page 6)

6
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WOODSTOVES WITh LEG BASE
Step . Using a 9/16” wrench or socket loosen the left heat shield bolt.
This bolt is located on the bottom side of the leg heatshield as
shown. See Figure 26.
Figure 26
Step 2. Insert snap switch bracket between the heatshield and the bottom
of firebox making sure entire assembly is on the left side of the
heatshield bolt. Slide back until the notch on the bottom front of
the bracket falls into the lip on the front of the heatshield, and as-
sembly is parallel with side of firebox. See Figures 27 and 28.
Figure 27
Left heat Shield Bolt
Figure 28
Step 2. Plug the power cord into a grounded 120 VAC receptacle. Do
not route the power cord under the stove or allow it to come in
contact with any surface of the stove.
Step 9. Using a 9/16” open end wrench tighten down the 3/8” bolt hold-
ing the control box. See Figure 23.
Step 0. Connect the wire harness from blower to female connector on
rear of snap switch bracket. See Figure 24.
Figure 23
Figure 24
Snap Switch Bracket
heat Shield
Snap Switch Bracket
Step . Visually inspect wires are clear of contact with bottom of firebox.
See Figures 23 through 25.
Figure 25
Snap Switch harness