Tu 2, Changing the bass and treble – Linn Kolektor User Manual
Page 27
12
The function of each key is explained in the following table:
Press this key
To do this
M
Mute or unmute the sound.
SRC- and SRC+
Select the previous/next source.
RECORD
Lock and unlock the current input to avoid
accidentally changing the input while recording.
VOL- and VOL+
Adjust the volume.
*
Select the bass.
+
Select the balance.
!
Select the treble.
(
and
)
Adjust the bass, balance, or treble selection.
SRC-
SRC+
RECORD
VOL-
VOL+
?
-
&
>
<
M
tu 2
BASS
BALANCE
MUTE
RENAME
SOURCE
VOLUME
LOCK
TREBLE
CURRENT SOURCE NAME
AND INPUT
SELECT BALANCE
SELECT BASS
ADJUST BASS, BALANCE,
OR TREBLE
SELECT TREBLE
NEXT
SOURCE
RECORD
SOURCE
REDUCE
VOLUME
INCREASE
VOLUME
PREVIOUS
SOURCE
MUTE
17
While you are adjusting the balance the display will show the
current balance setting, and the BALANCE indicator will be lit:
9~-_
BALANCE
==
BALANCE
_-~9
BALANCE
CENTRE POSITION
FULLY RIGHT
FULLY LEFT
While you are adjusting the balance press
+ to restore the balance
towards the centre position.
Changing the bass and treble
The KOLEKTOR has individual bass and treble controls to allow you
to adjust the sound to suit a wide range of speakers, sources, and
room acoustics.
To change the bass or treble
or
0
BASS
5
BASS
? &
>
<
Press
* or ! (front panel) to display the current bass or treble
setting respectively. Then use
( and ) (front panel) to set the bass
or treble as required.
Alternatively press BASS- or BASS+ (handset) to set the bass or
TREB- or TREB+ (handset) to set the treble.
You can change the bass and treble from -7 (maximum cut),
through 0 (level), to +7 (maximum lift).
After adjusting the bass or treble the display will revert to normal
after a delay. While you are adjusting bass or treble, pressing
* or
! will restore the value towards zero.