Logan Graphic Products LONG F100-4 - Manual (Page 4)

3
Assembly Procedure
1. Remove clamp and rod (Fig.1).
a. Unscrew nut and bolt. Keep spacer.
Discard nut and bolt.
2. Remove base board (Fig.2).
a. Remove four base screws.
3. Fence
a. Attach fence extension to left hand fence.
Feed sections together thru connector
plates (Fig 3).
b. Tighten set screws.
c. Attach leg to fence (Fig. 4).
d. Peel scale backing paper and carefully lay
scale flat onto fence. Start at intersection
and slowly lay scale down toward end of
fence (Fig. 5).
e. Align fence sections onto saw base. Install
screws thru back of saw base into fence
(Fig. 7).
f. Install screws thru bottom of saw base
(Fig. 6).
Instruction Manual Model F100-4 SAW FENCE KIT
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7