Life Fitness 95SE - Manual (Page 5)

10
16
CX
C
A
B
16
10
D
A
2
1
15
E
10
C
F
1. Before proceeding, familiarize yourself with the parts of the
Stairclimber and make sure that you have received all the items
described in the Parts List.
2. Locate the MONOCOLUMN (#10). Position the MONOCOLUMN
SHROUD (#16) onto the MONOCOLUMN as shown. Position the
MONOCOLUMN near the MONOCOLUMN MOUNTING BRACKET
(A) as shown. Detach and feed the CONSOLE WIRE HARNESS (B)
and COAXIAL CABLE (CX) through the MONOCOLUMN and out
through the DISPLAY CONSOLE MOUNTING BRACKET (C)
ACCESS HOLE. Pivot the MONOCOLUMN upright and position the
locating slot at the bottom of the MONOCOLUMN onto the pre-
installed LOCATING BOLT (D) on the MONOCOLUMN MOUNTING
BRACKET. Align the mounting holes of the MONOCOLUMN and
MONOCOLUMN MOUNTING BRACKET and secure them together
using two MOUNTING BOLTS (#1) and LOCKNUTS (#2). Leave the
BOLTS and NUTS loose at this time. Lower the MONOCOLUMN
SHROUD until it rests on the MAIN SHROUDS.
CAUTION: Be careful not to pinch the COAXIAL CABLE or WIRE
HARNESS (C).
MISE EN GARDE : veillez à ne pas pincer le CÂBLE COAXIAL ou
CÂBLE PRINCIPAL (C).
3. Align and insert the HANDLEBAR ASSEMBLY (#15) into the
HANDLEBAR BRACKET TUBE (E) as shown until the mounting
holes in the HANDLEBAR ASSEMBLY align with those of the
HANDLEBAR BRACKET TUBE.
4. Locate the HEART RATE CABLE (#18). Feed the 4-PIN CONNECTOR (4P)
end of the cable through the front of the HANDLEBAR ASSEMBLY (#15).
The cable must be routed down the HANDLEBAR BRACKET TUBE (E) and
back up the top of the MONOCOLUMN (#10). Feed the 4-PIN CONNECTOR
through the DISPLAY CONSOLE MOUNTING BRACKET (C) ACCESS
HOLE. Pull the LEFT HEART RATE SENSOR CABLE (2PL) (Labeled LEFT)
through the LEFT LARGE HOLE (F) of the HANDLEBAR BRACKET TUBE.
Pull the RIGHT HEART RATE SENSOR CABLE (2PR) (Labeled RIGHT)
through the RIGHT LARGE HOLE of THE HANDLEBAR BRACKET TUBE.
10
15
E
C
2P
4P