Life Fitness 95SE - Manual (Page 7)

5
10
D
5
11
9
H
CX
17
G
K
J
8. Using four MOUNTING SCREWS (#5), attach the ACCESSORY TRAY (#11)
to the DISPLAY CONSOLE (#9) as shown.
CAUTION: Do not over-tighten the SCREWS (#5).
MISE EN GARDE : Ne serrez pas trop les VIS (Nº 5).
9. Attach all CABLES (H, CX) leading from the DISPLAY CONSOLE
MOUNTING BRACKET (C) ACCESS HOLE to the back of the DISPLAY
CONSOLE (#9). Connect the COAXIAL CABLE (CX) first. Followed by the 5-
PIN, 4 PIN and 14 PIN CONNECTORS.
10. Feed any excess cable into the MONOCOLUMN (#10). Using four
MOUNTING SCREWS (#5), secure the DISPLAY CONSOLE (#9) to the
DISPLAY CONSOLE MOUNTING BRACKET (C).
CAUTION: Do not over-tighten the PHILLIPS HEAD PAN SCREWS (#5).
CAUTION: Be careful not to pinch the CABLES (H, CX) when assembling the
CONSOLE ASSEMBLY (#9) to the DISPLAY CONSOLE MOUNTING
BRACKET (C).
MISE EN GARDE : Ne serrez pas trop les vis cruciformes à tête cylindrique
(Nº 5).
MISE EN GARDE : Veillez à ne pas pincer le faisceau de CÂBLES (H, CX)
lors du montage de la CONSOLE (nº 9) sur son SUPPORT (C).
11. Secure the MONOCOLUMN SHROUD (#16) to the MAIN SHROUD using
four MOUNTING SCREWS (#7).
CAUTION: Do not over-tighten the PHILLIPS HEAD PAN SCREWS (#7).
MISE EN GARDE : Ne serrez pas trop les VIS CRUCIFORMES À TÊTE
CYLINDRIQUE (Nº 7).
12. Insert the FRAME CAPS (#17) into the ends of the FRAME LEGS (G).
13. After placing the stairclimber in the intended location for use, check the
stability of the stairclimber. If the stairclimber is not level, turn a LEVELER (J)
in one of the FRAME LEGS (G) in either direction until the rocking motion is
eliminated. Tighten the JAM NUT (K) when the stairclimber is level.
NOTE: Only one leveler needs to be turned.
REMARQUE : Ne tourner qu’un seul vérin.
14. With the stairclimber in the intended location for use and stabilized, locate the
supplied POWER SUPPLY and LINE CORD. A coaxial broadcast supply line
with an F-Type connector (L) (not supplied) is required for entertainment
viewing. Connect the POWER SUPPLY CONNECTOR (M) to the appropriate
connector located on the front of the stairclimber. Connect the broadcast
supply line at this time if available. Connect the LINE CORD to the POWER
SUPPLY and plug the LINE CORD into a power outlet.
NOTE: Refer to the operation manual for specific power requirements.
REMARQUE : Regardez du manuel d'opération pour l'alimentation
électrique spécifique.