Switching on your monitor, Setup diskette for windows 2000 – Lenovo T54H User Manual
Page 6
7
DEUTS
C
H
EN
GLI
S
H
F
R
ANÇAIS
ES
P
A
ÑOL
IT
ALIA
NO
JAP
ANE
SE
COMP
L & W
A
R
R
The AC adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a different
stand, see Further Help on
page 25.
Switching on your Monitor
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3.
Turn on the monitor and then the computer.
4.
Run
A
UTO
S
ETUP
by following the instructions in the
Configuring your
Monitor
section on page 6.
Setup Diskette for Windows 2000
This section must be
completed before
continuing with the
Windows 2000 confguring
for your monitor on page 11.
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Flat Panel Monitor Installation diskette.
1.
Turn off the computer and all attached devices.
2.
Ensure that the monitor is connected correctly.
3.
Turn on the monitor and then the system unit. Allow the system to boot
into Windows 2000.
4.
Open the
D
ISPLAY
P
ROPERTIES
window by clicking on
S
TART
,
S
ETTINGS
,
C
ONTROL
P
ANEL
and then double clicking on the
D
ISPLAY
icon.
5.
Select the
S
ETTINGS
tab.
6.
Select the
A
DVANCED
button.
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends using
1024 x 768 at a refresh rate of
60Hz.
7.
Select the
M
ONITOR
tab.
8.
Select the
P
ROPERTIFS
button.
9.
Select the Driver
tab.
10. Open theUpgrade Device Driver Wizard window by clicking on UPDATE
DRIVER and then select the NEXT button.
11.
select the “Display a list of the known dirvers for this device so that lcan
choose a specifc driver” and then sefect the NEXT button.
12. Inset the Setup diskette into drive A: and select the HAVE DISK button.
13. select OK.
U65C`tfuvq/cbdlvq/gn Qbhf 8 Xfeoftebz- Kvmz 23- 3111 5;1: QN