LevelOne SIP IP PBX VOI-9300 - Manual (Page 8)

2007-11-21 8 8
6. Installations
7. Reset to Factory Default
IP PBX VOI-9300 can be reset back to factory default when IP address is not accessible for web
configurations. The procedures are as follows:
1. Power off.
2. Press the RESET button and hold continuously, then power on.
3. Hold the RESET button until all the LED indicators start flashing for three times. It may take 15-20
seconds to reset, and the RESET button can then be released after flashing.
4. The LED indicators will begin flashing for 3 times again to activate the IP PBX. Note that the
firmware version and IP settings will be reset back to factory defaults and users data base will be
cleared.
5. It is suggested that the user data base be exported and backed up to PC before reset.
Internet
ADSL
modem
IP Phones
FXS
FXO
LAN
Life Line POTS
WAN
PSTN
Ethernet Switch Hub