Linksys EF1324 - Manual (Page 32)

EtherFast ® Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch
Protocol Configuration
The Protocol Configuration screen is used to globally enable or disable uni-
cast or multicast routing protocols for the Switch.
• ARP - Address Resolution Protocol. Select Advanced for additional
configuration (see page 23).
• Proxy ARP - Enable or disable the Proxy Address Resolution Protocol.
• RIP - Enable or disable the Routing Information Protocol for unicast
routing. Select Advanced for additional configuration.
• OSPF - Enable or disable the Open Shortest Path First protocol. Select
Advanced for additional configuration.
• DHCP Relay - Enable or disable the Dynamic Host Configuration
Protocol relay. Select Advanced for additional configuration.
• IGMP Snooping - Enable or disable IGMP multicast filtering. Select
Advanced for additional configuration.
• DVMRP - Enable or disable the Distance-Vector Multicast Routing
Protocol.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
57
Instant EtherFast ® Series
Add Subnet
The Add Subnet screen allows you to add an IP interface.
• VLAN - The VLAN associated with this IP interface.
• Select - Use this option to create or modify a VLAN.
• IP Address - The IP address associated with the specified VLAN
interface.
• Subnet Mask - A template that identifies the address bits in the
host address used for routing to specific subnets.
• Proxy ARP - Enable or disable the Proxy Address Resolution
Protocol.
• RIP - Enable or disable the Routing Information Protocol for
unicast routing.
• OSPF - Enable or disable the Open Shortest Path First protocol.
• DVMRP - Enable or disable the Distance-Vector Multicast Routing
Protocol.
Select OK to confirm the changes. Select Cancel to cancel any changes.
56