Linksys SRW2024 - Manual (Page 52)

42 Chapter 5: Using the Web-based Utility for Configuration
VLAN Management Tab - Ports to VLAN
WebView Switches
Acceptable Frame Type. Packet type accepted on the port. Possible values are:
• Admit All. Indicates that both tagged and untagged packets are accepted on the port.
• Admit Tag Only. Indicates that only tagged packets are accepted on the port.
PVID. Assigns a VLAN ID to untagged packets. The possible values are 2 to 4094. VLAN 4095 is defined as per
standard and industry practice as the discard VLAN. Packets classified to the Discard VLAN are dropped.
Ingress Filtering. Enables or disables Ingress filtering on the port. Ingress filtering discards packets which do
not include an ingress port.
LAG. Indicates the LAG to which the VLAN is defined.
VLAN Management Tab - Ports to VLAN
The Ports to VLAN screen contains fields for configuring ports to a VLAN. The port default VLAN ID (PVID) is
configured on the Create VLAN screen. All untagged packets arriving to the device are tagged by the ports PVID.
The Ports to VLAN screen contains a Port Table for VLAN parameters for each ports. Ports are assigned VLAN
membership by selecting and configuring the presented configuration options.
VLAN. The VLAN number.
Access. Indicates the port belongs to a single untagged VLAN. When a port is in Access mode, the packet types
which are accepted on the port cannot be designated. Ingress filtering cannot be enabled/disabled on an access
port.
Trunk. Indicates the port belongs to VLANs in which all ports are tagged, except for one port that can be
untagged.
General. Indicates the port belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q
mode).
Tagged. Defines the interface as a tagged member of a VLAN. All packets forwarded by the interface are tagged.
The packets contain VLAN information.
Untagged. Packets forwarded by the interface are untagged.
Forbidden. Forbidden ports are not included in the VLAN.
Figure 5-12: VLAN Management - Ports to VLAN