User manual, Features – Lindy 32388 User Manual
Page 2
USER MANUAL
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (June 2002)
Please read this guide thoroughly and follow the installation and operation
procedures carefully in order to prevent any damage to the units and/or any
devices that connect to them.
Package Contents
This package contains:
1. 1 Cat.5 KVM Extender USB Local Unit
2. 1 Cat.5 KVM Extender USB Remote Unit
3. 2 Power Adaptors
4. 1 User Manual
If anything is damaged or missing, please contact your dealer.
Features
•
Category 5 STP or FTP Ethernet Cable to Connect the Local and Remote Units (Up to 150m apart)
•
Auto Signal Compensation (ASC)
•
USB Keyboard and USB Mouse Ports
•
Dual Console Operation - Control Your System From Both the Local and Remote USB Keyboard, USB
Mouse, and Monitor Consoles
•
USB Over current Detection and Prevention
•
Push Button Selection of the Active Console
•
High Resolution Video - Up To 1280 x 1024
•
Supports VGA, SVGA, and Multisync Monitors
•
Local Monitor Support: DDC; DDC2; DDC2B
•
Hot Pluggable
CE remark
This equipment has been tested and found to comply with the limits for Information Technology Equipment of the European Community.
FCC remark
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that which the receiver is connected
•
Consult the dealer or an experienced radio/television technician for help.