LevelOne WBR-3402TX - Manual (Page 23)

23
4.4.1.3 IP over ATM (RFC 1483 Routed)
In the Router Mode, NAT is always enabled. You have to set the following WAN IP settings:
WAN IP Mode:
This product supports two WAN IP modes: static and dynamic. If you select dynamic mode, it will try
to get a legal IP and WAN settings from ISP’s DHCP server. If you select static mode, you have to set
the following WAN setting manually.
WAN IP Address, WAN Subnet Mask, WAN Gateway, and Primary/Secondary DNS
These settings are assigned by your ISP.
VPI/VCI Numbers:
The channel settings provided by your ISP.
Schedule Type:
The setting of the ADSL traffic schedule type. This device supports UBR (Un-specified bit rate) and
CBR (Constant bit rate). Once you finished the required configuration, you must click on the
"Save" button to save the configuration into Flash memory, and the reboot this device.