Lenovo 3000 Y410 User Manual

Page 57

Advertising
background image

Replacing Memory

Chapter 5. Upgrading and Replacing Devices

49

To install an SO-DIMM, do the following:
1.

Touch a metal table or a grounded metal object. This action reduces any
static electricity in your body, that could damage the SO-DIMM. Do not
touch the contact edge of the SO-DIMM.

2.

Turn off the computer

; then disconnect the ac adapter and all cables

from the computer.

3.

Close the computer display, and turn the computer over.

4.

Remove the battery.

5.

Unfasten the two screws a on the cover and remove the cover b.

6.

Find the notch on the contact edge side of the SO-DIMM.

Attention:

To avoid damaging the SO-DIMM, do not touch its contact edge.

7.

With the notched end of the SO-DIMM toward the contact edge side of
the socket, insert the SO-DIMM into the socket at an angle of about
20 degrees, then press it in firmly a.

8.

Push the SO-DIMM down until it snaps into place.

2

1

1

1

1

2

Lenovo 3000Y410 UG.book Page 49 Friday, September 14, 2007 1:37 PM

Advertising