Land Pride RC5010 User Manual
Page 4
2
RC5010 & RC6010 (540 RPM) and RCM5010 & RCM6010 (1000 RPM) Rotary Cutters 318-128M
8/28/08
Land Pride
Important Safety Information
Transport
Machinery Safely
▲
Comply with state and local laws.
▲
Maximum transport speed for
implement is 20 mph. DO NOT
EXCEED. Never travel at a speed
which does not allow adequate
control of steering and stopping.
Some rough terrain require a
slower speed.
▲
Sudden braking can cause a
towed load to swerve and upset.
Reduce speed if towed load is not
equipped with brakes.
▲
Use
the
following
maximum
speed - tow load weight ratios as
a guideline:
20 mph when weight is less
than or equal to the weight of
tractor.
10 mph when weight is double
the weight of tractor.
IMPORTANT: Do not tow a load that
is more than double the weight of
tractor.
Use Safety
Lights and Devices
▲
Slow-moving tractors, self-
propelled equipment and towed
implements can create a hazard
when driven on public roads. They
are difficult to see, especially at
night.
▲
Flashing warning lights and turn
signals are recommended
whenever driving on public roads.
Use lights and devices provided
with implement.
Use A Safety Chain
▲
A safety chain will help control
drawn machinery should it
separate from the tractor
drawbar.
▲
Use a chain with the strength
rating equal to or greater than
the gross weight of the towed
machinery.
▲
Attach the chain to the tractor
drawbar support or other
specified anchor location. Allow
only enough slack in the chain to
permit turning.
▲
Do not use safety chain for
towing.
These are common practices that may or may not be applicable to the products described in
this manual.
Practice Safe Maintenance
▲
Understand procedure before
doing work. Use proper tools and
equipment, refer to Operator’s
Manual for additional information.
▲
Work in a clean dry area.
▲
Lower the implement to the
ground, put tractor in park, turn off
engine, and remove key before
performing maintenance.
▲
Allow implement to cool
completely.
▲
Do not grease or oil implement
while it is in operation.
▲
Inspect all parts. Make sure parts
are in good condition & installed
properly.
▲
Remove buildup of grease, oil or
debris.
▲
Remove all tools and unused
parts from implement before
operation.