LG LDX-514 - Manual (Page 40)

40
T T roubleshooting roubleshooting
Symptom
No power.
Abnormal or no picture
Distorted or no sound.
The playback picture is
poor.
Cause
The power cord is disconnected.
The TV is not set to receive DVD+VCR
signal output.
The video cable is not connected
securely.
The HDMI mode is on.
Unit output setting and TV resolution
capabilites mismatch.
Wrong cable connection.
The equipment connected with the
audio cable is not set to receive
DVD+VCR signal outpt.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The AUDIO options are set to the wrong
position.
In HDMI mode, audio selection is not
set to PCM.
The disc is dirty.
The TV channels are not tuned in
properly.
Tape heads are dirty.
Tape is a rental or was recorded on
another VCR.
Correction
Plug the power cord into the wall out-
let securely.
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
Select the appropriate video input
mode on the TV so the picture from
the DVD+VCR player appears on the
TV screen.
Set HDMI on the front panel to OFF.
Check TV capability.
Check mode of connections
(eg. S-Video, Components etc.).
Check unit Resolution setting accord-
ing to TV capability and mode of con-
nection.
Check the connection.
Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with
the audio cable.
Set the AUDIO options to the correct
position.
Change AUDIO setup to PCM mode.
Clean thd disc.
Check tuning, carry out tuning again.
Clean video heads.
Use CH/TRK (+/-) for manual tracking
adjustment while tape is playing.
Check the following guide for the possible cause of a problem before contacting service.