Life Fitness LIFECYCLE M051-00K67-A151 User Manual
Page 8
7
1.2
S
ETUP
Read the Operation Manual before setting up the Upright Lifecycle Exercise Bike.
E
LECTRICAL
P
OWER
R
EQUIREMENTS
The Upright Lifecycle Exercise Bike with the Engage
TM
Console (15” LCD) requires an AC power supply according to the
electrical configurations listed in the chart below. External power is optional with the Inspire
TM
Console (7” LCD) and
Achieve
TM
Console (LED).
NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a prop-
er outlet installed by a qualified electrician.
W
HERE TO
P
LACE THE
U
PRIGHT
L
IFECYCLE
®
E
XERCISE
B
IKE
Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 3, titled
Specifications, for the dimensions of the product footprint (assembled dimensions). Allow a distance of 8 to 12 inches, or 21
to 30 centimeters, between the bike and other objects or surfaces on either side. Allow a distance of 3 feet, or 1 meter, from
the front or rear of the bike to any other object or surface.
H
OW TO
S
TABILIZE THE
U
PRIGHT
L
IFECYCLE
®
E
XERCISE
B
IKE
After placing the bike in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking
indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut
(A) with an open-end M17 wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat
the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the
stabilizer bar.
.
C
HECK FOR
B
ATTERY
P
OWER
The Achieve and Inspire consoles are powered by a rechargeable 6-volt battery. Check the battery by pressing and hold-
ing the power on/off key. The console should beep and light up. The Message Center on the Achieve console will
display a prompt to set up a workout. The Inspire console will show a message on the LCD indicating it is initializing (for
up to 2 minutes). If a prompt doesn’t appear or initializing doesn’t begin, mount the Upright Lifecycle Bike and begin ped-
aling. The console should light up and programming a workout should be possible. Pedal for 20 minutes at 40 RPM or faster
during a workout to charge the battery. The pedal action during workouts keeps the battery charged. If the Lifecycle Exercise
Bike is externally powered by the 36V DC power supply, battery maintenance is automatic and pedaling is not required.
A
B
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8