Loewe Xelos SL 20 SAT - Manual (Page 10)

10
G) In the “LNC frequency(ies)” menu, set
the oscillator frequency for the LNC. The
correct display of the reception frequency in
the “Set channels manually” menu depends
on this.
The frequency can be altered
using the right/left arrows on
the ring.
Note
The oscillator frequency is given in the LNC
description or on the LNC, e.g. 9.75 GHz (9750
MHz) or 10.6 GHz (10600 MHz).
Confirm your entries using the OK button and
this will take you to the “Align/Pre-
program” menu.
If your antenna is pointing directly at a
satellite, you should be able to receive a
television programme.
Use the up / down arrows
imprinted on the ring of the
remote control to select a line /
term in the menu
confirm the selection with OK,
this will save a setting or
take you to the next menu.
Make a selection using the
right/left arrows, or change the
settings.
➝
First installation
Selecting and adjusting
using the remote control
and the on-screen menus
The line / function selected from the menu is
displayed in blue.
The buttons for the relevant operation are
depicted symbolically in the lower part of a
menu. Possible directions for making selections
are represented by solid black arrow head(s).
Additional button symbols are displayed for
other operating options in a menu. Use MENU
to take you back to the previous menu or END
to remove the menu.
For example:
O K
First installation
Deutsch
English
Français
Español
Italiano
Nederlands
Dansk
Svenska
Cesky
Polski
Português
Select and
proceed with OK
Which language do you want
to use for operation?
O K M
E
Align/preprogram
You should now have a good
reception from the
following satellite:
Sat. 1 ASTRA
Back
End
Align,
select and
continue with OK
Preprogramming no yes
If not, please aling your
antenna correctly
Preparing automatic
programming
Follow the menus and perform the necessary
adjustments in the following sequence.
A) First you have to select the menu language
for your TV set using the remote control.
B) Pressing the OK button will take you to the
“Location of TV set” menu.
Indicate the country in which you are using
the appliance.
C) Pressing the OK button will take you to the
“Satellite System” menu.
D) Select the unit in correspondance to your
satellite antenna.
If necessary, ask you aerial installer or
your dealer about the type of satellite
aerial system and the aerial settings.
In the “Satellite System” menu, indicate
whether your aerial system receives channels
from one satellite or from more than one.
If you only receive from one satellite...
E) Select the satellite at which your aerial is
directed, e.g. ASTRA.
If you want to program and receive a satellite
other than the ones shown in the menu, then
select ”Other”. Use the menus to enter the
satellite specific data, which can be found in
satellite magazines or obtained from your
dealer. The full procedure is described in the
section entitled ”Programming other
satellites” on page 11.
F) In the ”High band” menu, indicate
whether it is possible to switch from low to
high band using your satellite aerial.
Note
The Astra, Hotbird (13° East) and Telecom 2B
satellites already have pre-programmed
television programmes.
If you want to use this pre-programming
facility, then select ”Pre-programming, Yes”
and ...
carry out the operating steps H and I, see Page
11
or ...
when you can receive two or more
satellites, select from ...
OK
OK
OK
OK
LCD_SAT_31715022_GB 10.08.2004, 15:44 Uhr 10